Thread: Stepper wiring/colour coding
Threaded View
-
22-06-2014 #11
Last Activity: 28-05-2023
I do not use win 8, on my CNC computer I have XP, so my comments may be qualified by ignorance, however :-
If such a concept still exists in win 8, you need to go into Control Panel, System, Hardware Devices and where the printer port is installed, check the address of the port. This should be set the same in Mach3 ports and pins setup. If these are different, you haven't a hope. The parallel port I/O cards sometimes install with non-legacy port addresses and assuming it is 278 or 378 is not necessarily correct.
The pinout I have for this board is X step 16 dir 1, Y step14, dir 7, Z step 3 dir 6Last edited by cropwell; 22-06-2014 at 03:50 PM.
-
The Following User Says Thank You to cropwell For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper motor tunning wiring
By handyoodman03 in forum Stepper & Servo MotorsReplies: 47Last Post: 11-01-2013, 05:49 PM -
Stepper Motor Wire Colour Codes
By c cunningham in forum Stepper & Servo MotorsReplies: 14Last Post: 26-01-2011, 02:13 PM -
CY or SY cable for stepper motor wiring?
By Jonathan in forum General ElectronicsReplies: 6Last Post: 26-09-2010, 06:25 PM -
Stepper motor wiring
By Buba b in forum Stepper & Servo MotorsReplies: 5Last Post: 28-03-2010, 06:16 PM -
Stepper Motor Wiring (Screened?)
By pequod in forum Stepper & Servo MotorsReplies: 19Last Post: 03-08-2009, 10:15 AM
Bookmarks