Threaded View
-
15-07-2014 #4
Cheers Eddy - yeah, I was leaning that way - although a micro DIY vacuum chuck might make a nice project... Will look into it a bit further to see if it's something that I could manage...
Clive S made a very good point earlier - I'm losing 20% of holding strength by using only the 1 strip of tape and leaving part of the blank 'unstuck'... Never really stopped to consider it, but when written down in numbers it becomes a lot more obvious!
Wal.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Z-Plunge advice sought...
By Wal in forum Machine DiscussionReplies: 3Last Post: 17-11-2013, 01:43 PM -
Advice Sought for Lathe
By Washout in forum Lathes, Lathe Rebuilding & ConversionsReplies: 13Last Post: 13-11-2013, 12:32 AM -
Holding down sheet material.
By jcb121 in forum Machine DiscussionReplies: 3Last Post: 03-07-2013, 12:11 AM -
holding mdf down to bed
By kell in forum General DiscussionReplies: 8Last Post: 13-07-2012, 02:59 PM -
Help and Advice sought about new motor for my mill
By alanb in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 26-01-2012, 08:04 PM
Bookmarks