Thread: Initial Design Check Please
Threaded View
-
16-07-2015 #18
Last Activity: 08-10-2019
They look close but there is about 1 to 2 cm between the heat sync and the next unit. There are two 80mm 24v fans at the top of the case and 3 60mm inlet holes at the bottom. If there is a problem ill mill and install a fan onto the drives heat sync.
Trev
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 5 users browsing this thread. (0 members and 5 guests)
Similar Threads
-
Initial workpeice tooling set-up instructions using a pendant controller type machine
By Nthkentman in forum Machine DiscussionReplies: 25Last Post: 30-08-2014, 08:33 PM -
Component Check
By manofgresley in forum General ElectronicsReplies: 1Last Post: 22-04-2014, 06:04 PM -
Initial thoughts on new build
By Neale in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 25-01-2014, 11:05 PM -
Some initial questions....
By andy586 in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 27-01-2013, 03:00 PM -
Newbie Initial Wiring/Setup
By Rikk in forum Motor Drivers & ControllersReplies: 3Last Post: 28-06-2011, 10:19 AM
Bookmarks