Thread: Fill in my knowledge gap :)
Threaded View
-
07-06-2016 #11
Hi Dave,
Just knocked this together to help work it out.
You can use one of the 3 look up tables depending on if the chamfer tool is 90, 60, or 45 deg.
Then assuming you use a notional tool diameter of 4mm as suggested above by needleworks in the CAM tool definition, then you just need to look up the required chamfer distance you require (C) and read off the depth of cut required (P) and enter this value into the CAM software.
I've not tried this out but I think it is OK. Please check on a scrap piece first (!).
Any errors spotted by anyone let me know . . .
-
The Following 2 Users Say Thank You to routercnc For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
how to fill/paint letters that i have engraved in wood ?
By cockneyrebel in forum Wood Finishing Tips & TricksReplies: 11Last Post: 26-03-2013, 11:21 PM
Bookmarks