Thread: Clearpath or DMM
Hybrid View
-
28-03-2021 #1
when I had two of my ~20 year old brushed servos go out, I replaced them with ClearPath units. This has been a few years ago and they are still doing an admirable job. Very silent also.
I chose them to retrofit as it was an easy replacement. They include all the electronics for step/direction and was compatible with my existing power supply. So for me it was a no brainer. Hooked up the step/direction lines and the power cable. Did a new calibration and was back in business.
Cant say about the DMM as I have no experience.
Good luck.Art
AKA Country Bubba
(Older than Dirt)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
New DIY CNC with MACH4 ESS/MB3 and clearpath servo
By Darko in forum General ElectronicsReplies: 5Last Post: 19-01-2021, 02:54 PM -
Clearpath servo groupbuy?
By komatias in forum Manufacturer NewsReplies: 2Last Post: 26-07-2017, 09:02 AM
Bookmarks