Threaded View
-
21-06-2011 #2
Last Activity: 22-12-2013
Is it getting the curves all wrong? There are two ways of handling curves in mach 3, absolute and incremental.
Go into 'config', then 'general config' and change the 'IJ Mode' setting. restart mach 3 and see if it has fixed the problem.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Am I heading in the right direction?....
By Lloyd in forum Gantry/Router Machines & BuildingReplies: 24Last Post: 24-06-2014, 09:09 PM -
NEW MEMBER: New Member desperate to learn
By Mill Grav Newbie in forum New Member IntroductionsReplies: 3Last Post: 24-04-2012, 01:17 PM -
NEW MEMBER: New Member, saying Hello and hoping for direction
By GMNOCNC in forum New Member IntroductionsReplies: 0Last Post: 07-03-2011, 11:50 AM -
sudden change of direction
By Dan Brown in forum Motor Drivers & ControllersReplies: 4Last Post: 06-03-2010, 11:30 AM -
Reversing motor direction in Mach3
By bruce_miranda in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 16-11-2008, 06:54 PM
Bookmarks