Thread: Connect spindle to mach
Hybrid View
-
11-03-2016 #1
Wondering if anyone can point me in the right direction on how to wire my spindle to mach3. At the minute I'm controlling it manually.
Last edited by Duffman; 11-03-2016 at 12:24 AM.
-
11-03-2016 #2
Will need more info. What spindle you got and what breakout board
https://emvioeng.com
Machine tools and 3D printing supplies. Expanding constantly.
-
11-03-2016 #3
Trying to get pic uploaded but they won't go on. I will try from the laptop when I get to workshop.
-
11-03-2016 #4
I'm going out on a limb here - you have a 1.5 or 2.2kw spindle and vfd from eBay or aliexpress etc???
Do you want speed control or just on/off control??
If you google Huanyang vfd Mach3 you should get some results.
As i said though - this is all presumption but this is a very common combination.
-
11-03-2016 #5
-
11-03-2016 #6
That BOB does not have the ability to run the spindle speed control but it can be made to switch the spindle on and off.
Have a look on Eurikain's thread about electrical stuff. I seem to remember Jazz had describe the pins you need to connect up to the BOB's relay.https://emvioeng.com
Machine tools and 3D printing supplies. Expanding constantly.
-
13-07-2020 #7
I'm lost too
-
14-07-2020 #8
Can I also wire manually as I'm using a cheapo cnc from China 3040. It was mentioned in the instructions that I should not do it as it can damage the controller
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to connect 2.2KW Inverter VFD?
By Tenson in forum Spindles & Drive MotorsReplies: 20Last Post: 13-07-2020, 01:47 PM -
got 2 outputs from controller, need to connect 3 leds to them, any solution?
By Noplace in forum CS-Lab (CSMIO)Replies: 5Last Post: 04-02-2016, 08:51 PM -
Connect 121 revamp
By Miller in forum Conect LathesReplies: 2Last Post: 16-10-2014, 05:42 PM -
Mach lathe spindle speed control
By GeoffV in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 21-05-2014, 08:34 AM -
How to connect my driver to my steppers
By speedhound in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 16-01-2011, 02:52 PM
Bookmarks