Play in my mount

[cropwell]

My guess is that you have this mount https://damencnc.com/en/tools/kress/...ling-motor/147 and there is a plate bolted to the mount, which in turn bolts to the Z axis and it is the plate bolted to the mount which has worked loose.

If that is so you will need to dismantle and reassemble using threadlock. There is also the possibility that the bolts are slightly too long and are bottoming on the thread. Anyway, you will need to get it apart to see what is going on.

Yep, the red wedges are too thick, try a green one

Rob

[CrazeUK]

My guess is that you have this mount https://damencnc.com/en/tools/kress/...ling-motor/147 and there is a plate bolted to the mount, which in turn bolts to the Z axis and it is the plate bolted to the mount which has worked loose.

If that is so you will need to dismantle and reassemble using threadlock. There is also the possibility that the bolts are slightly too long and are bottoming on the thread. Anyway, you will need to get it apart to see what is going on.

Yep, the red wedges are too thick, try a green one

Rob

I think it looks very similar. I'll take the whole thing off and see if I can get a better pic, or tighten.

The yellow one seems a bit soft for the job. 🤔

Sent from my SM-N930F using Tapatalk