Hybrid View
-
13-01-2019 #1
Was trying BK 12 Blocks and when tightening the nut it's either too lose and the screw has forward/backward play or it's too tight and the screw can't rotate :(
-
13-01-2019 #2
Dismantle the block and check everything is assembled the correct way.
There is history of these being assembled wrong, which gives the symptoms you've described.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
13-01-2019 #3
Did just that and all i see is just two bearings back to back.
-
-
15-01-2019 #5
should i adjust the nut to have minimum drag ? or do i tighten all the way and it should be fine ? if i should tighten all the way then the block is faulty. please clarify this point for me as all my knowledge is theoretical from forums and such.
-
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Halftoner, a marvel to make artwork
By eurikain in forum General ComputingReplies: 0Last Post: 25-08-2016, 01:04 PM -
WANTED: Chinese 1.5kw spindle/vfd
By Philly in forum Items WantedReplies: 5Last Post: 10-02-2013, 11:44 AM -
Delcam Advanced Manufacturing Solutions
By Andywarwick in forum Manufacturer NewsReplies: 0Last Post: 06-06-2011, 04:48 PM -
Microscopic manufacturing / artwork
By HiltonSteve in forum General DiscussionReplies: 7Last Post: 06-05-2010, 12:12 AM -
Additive layer manufacturing
By Lee Roberts in forum General DiscussionReplies: 1Last Post: 16-11-2008, 07:28 PM
Bookmarks