Wiring an enable / disable switch for each driver

[mbridge87]

Hey everyone,

I've been told it's really useful to add enable/disable switches for each driver on a motion control system but I don't understand how to wire this. I'd really appreciate some guidance.

Firstly here are the drivers I'm using:

3DM2283T - https://www.omc-stepperonline.com/di...ice&order=DESC

DM2282T - https://www.omc-stepperonline.com/di...ice&order=DESC

DM542T - https://www.omc-stepperonline.com/di...tepper%20Motor

I'm using Mantis and have a very simple BOB (pictured).



The switches and 5v PSU I've found are below although I'm not actually sure if these are appropriate.

Switches - https://uk.rs-online.com/web/p/rocke...B0fFgwsdTc1zVE

PSU - https://www.cnc4you.co.uk/PSU-5V-2A-Power-Supply

I think that's everything and thanks in advance for any help