Threaded View
-
21-01-2013 #1
Hi all,
I'm a bit confused as to what the minimum requirements are on a break out board. My planned system is a PC with LinuxCNC, BOB, drivers and stepper motors.
Take this for instance:
Obviously there are no opto couplers to protect the computer. But is anything else needed for comunicating with the stepper drivers?
Thanks
PatrikI've upped my standards. Now, up yours!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
MACH 3 requirements
By manofgresley in forum Artsoft Mach (3 & 4)Replies: 14Last Post: 08-01-2020, 07:22 PM -
are these a newwer version usb break out board the ones from austrailia - better?
By nobby in forum General ElectronicsReplies: 0Last Post: 13-02-2014, 07:09 PM -
Break board 3-axis optical isolation, simple!
By thjremy in forum Electronic Project BuildingReplies: 0Last Post: 06-04-2013, 04:42 PM -
optoport v3 break out board wiring
By lez allen in forum Motor Drivers & ControllersReplies: 4Last Post: 26-02-2013, 07:38 PM -
Motor controller next to break out board?
By m_c in forum General ElectronicsReplies: 2Last Post: 17-11-2010, 01:56 PM
Bookmarks