Thread: Plunging and ramping speeds
Threaded View
-
13-06-2014 #1
When cutting plywood I ramp the tool down into the wood rather than a straight plunge If I can.
Do you normally reduce the feedrates when entering the wood or is it better to use the same feedrate as your cutting feedrate?
Is there a way of calculating the best angle to ramp down with?
GavCNC routing and prototyping services www.cncscotland.co.uk
ADD ME ON FACEBOOKS
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Feeds and speeds
By dudz in forum Tool & Tooling TechnologyReplies: 0Last Post: 26-08-2013, 11:42 AM -
Countersink Cutter Feed & Speeds
By Mad Professor in forum Tool & Tooling TechnologyReplies: 0Last Post: 01-02-2013, 09:34 PM -
Advice needed on feeds and speeds!
By lateAtNight in forum Machine DiscussionReplies: 5Last Post: 14-11-2012, 12:47 PM -
Not getting speeds I thought I would?
By jonbabbz in forum General DiscussionReplies: 5Last Post: 29-09-2012, 09:56 PM -
Speeds and Feeds
By Web Goblin in forum Tool & Tooling TechnologyReplies: 0Last Post: 20-09-2012, 01:38 PM
Bookmarks