Hi
My homemade cnc Univelop TB6560 machine was going ok by my standards for quite some time (1.5 years) until the next day when I switched on the machine it won't run.


1) Motors - Vexta PK266-02A (Motors run 100%)
2) Univelop TB 6560 controller & Drivers
3) Mach 3 software


This is what I notice.
When I start up computer the light on Univelop BOB would light up as it always does. But as soon I start up mach 3 the light would go off.I have measured and checked voltage on DB25 parallel cable which seems ok. Have uninstalled and re-installed Mach 3 but problem persist.


I cannot understand what caused this sudden change.


Can you help please.


Thank you
Gasant