RYE QUANTUM - Omicron 3000 Controller SWAPOUT OPTIONS

[BEACHBLANKET]

I was thinking maybe something along the lines of UCCNC?

Sent from my Mi A1 using Tapatalk

[JAZZCNC]

I was thinking maybe something along the lines of UCCNC?

Sent from my Mi A1 using Tapatalk

It depends on the drives and if they have Step & Dir control inputs. If not then you can't use any of the UC line of controllers because they supply Step & Dir signals only.
Most older machines which use DC motors are +/-10v analog control inputs and often they will have Tacho's or resolvers on the motors, thou in your case it looks like you have encoders which makes things easier because worst case scenario you could change the drives for DC drives with Step & Dir signals. Thou it does depend on the encoders as well so you'll need to check them out.
CNC Drive who make the UC cards also make DC drives with Step & Dir.

You can get Motion controllers which provide +/-10V Analog output but they tend to be expensive and can be a bare to setup compared to step & dir.!

If the existing drives do have Step & Dir Inputs then it's a Doddle to convert with just a UC300 and Decent BOB that provides Spindle control and away you go.

Edit: But I'll say it again because it shouldn't be underestimated how much work is involved.!! . . . . You will have to setup and write your own ATC code or code to control dual spindles plus pneumatics etc. And this machine seems to have a few bells n whistles on it.!