Activity Stream

https://www.vectric.com/support/tutorials/aspire/?

Hi JazzCNC Do you know where I could get Aspire Professional Software. Thanks in advance

Overall I’m still happy with it. It started to cut off square but this was fixed by retightening the main pivot bolt for the arm. 400 Watts is fine...

First, check the spindle's nameplate for the rated current (usually in Insulated Bearing). For a 4kW spindle, this value is typically in the range of...

Why not try it first? Why wouldn't it be suitable?

Nice video. How is the machine now after a few years of use? Are you happy with it? Isn't 400W too weak? Just last week I bought a similar one, but...

I think the answer to that should be it depends on what you are working with and want to extract. I mean, personally, I don't use any mechanical...

Sounds like a leak to me (interference perhaps?), check all your earth (ground) wires are secure, make sure no control and power wires are in close...

They look OK, don't speak Polish You didn't say what you wanted machine wise so hard to judge and we buy 2nd hand mostly lol Just remember...

Lmao, a "McWine" haha :applause::beer:

hi chris i just went with the makita router . thought i could always upgrade later if i needed it

X axis gantry, cheap linear rails quick look, new Z axis touch off (again!) and Y axis movement.

Oops! Apologies I inserted the wrong link, the one I'm using has only one relay: ...

I have had a beer in McD's It was anti climatic It came in a can like a store I wanted a paper cup McD's beer!!!! Lithuania, they sold...

Wait...what?!?!... McDonald's do wine? Red or White?

Apologies for thread hijack, but perhaps John, or anyone using this ubiquitous board, can clear up a confusion with pins on the above board which I...

Youtube is your friend for what to do with it and upgrades Buy everything from Alixpress Good luck Honestly for this machine Vcarve is a...

I will do. I had an HPC CNC machine (from Halifax) for about 3 years and sold it in lockdown for almost twice what I paid for it. Due to health...

Thanks Chris . Appreciate the offer, I may switch but as I have a years free subscription when I bought the onefinity I am just going through all the...

Hello Dan. Im doing this a bit backwards. Im getting the software to master before I buy the CNC machine. Ive done down the route of Vectric...

Thanks. Can you let me know an idea of pricing. Not specifically looking at the centroid servo motors however that might be of interest if you have...

here are some pictures