Activity Stream

Apparently I can’t see your DM as a new user. Can you see mine?

Apparently I can’t see your DM as a new user. Can you see mine?

Ok here's my latest attempt. I think Pin 6 is now the Thermal switch, so I've added this to the input. As you stated, once configured in...

Picture was a mistake but it is of the USB convertor I used to make it work. I have more pictures of my machine that may help. Let me know. K

Send me your email address and I will be happy to send you the file.

You'll need to redo your wiring diagram to suit. You'd need to know the technical details for the temp sensor, but it looks like yours doesn't...

I'm a bit more confused now, I've just decided to physically have a look at the Spindle and took the Cover off to look at the Wiring Terminals and...

Hi again M_C, I know you've helped me before with wiring, so thank you for coming back! I've revised this a bit after looking at it again and...

I've only had a quick look, but the following things stand out- - Shouldn't the push button lamp be connected to an output? (You'd ideally want some...

How can I get the in touch with you. I just picked up up an AXYZ Millennium and would like to get a copy of your zip file. Hugh

Some items to remember in the design phase: Account for the width of your Z module on the gantry and also the type and position of your end stops....

For that kind of machine, rigidity is key, and mild steel will do better than aluminum in this case. Filling sections with epoxy granite could help,...

Yes I did, thank you.

Did you manage to sort this out Frank ?

Yea, I've never seen a complementary word said about it to be honest, Cent seems to be catching on quite widely I've noticed. Pleased you got it...

Thanks. I found a bit earlier today that under the CS LABS plugin you can select 'ignore limits whilst homing', so that's worked. Had to fix one...

Did you manage to sort this out Clive ?

Hi Chaz, In Mach4, using the same switch for both limit and home functions is possible, but it depends on the controller and configuration. ...

Have you asked over on the Mach support forum? https://www.machsupport.com/forum/index.php

A birt late to reply to this. I had a similar problem, same machine. I found the relay that controlled the spindle was a bit sticky. If you...

3D bas-relief portrait of the writer Jakob Schopmans for a memorial plaque.

Very clean!

SOLD: Thanks for the interest generated. The two machines are sold. This is a wonderful forum to be part of. Thanks David