Activity Stream

Here is a YouTube link to the whole rebuild condensed into 10minutes: https://youtu.be/gk-EpXEnTgc?si=PUR2XCp-rGPtyo4a

Hi Muzzer, The video isn't a backlash test, it's just for tuning the top rapid speeds and getting a better idea of the machine's limits. The...

As you say, looks as if a bomb went off - or a stoned spider wired the original cabinet up! It looks pretty neat now. Bear in mind that in order...

For those following along here is the next installment, getting the control boxes and DRO readout fitted. Thank you to JLCCNC machining services...

OK a bit of an update, after a lot of looking I eventually found the GT2 or 2GT belts are not only a close match to the originals but also stronger...

Well lets hope it does not need quite as much work as my machine did! I would recommend UCCNC UC300ETH it works very well and has lots of inputs...

Hi Mike, many thanks for such a comprehensive thread on the 260 rebuild. I do have a vested interest as recently purchased a 260, already converted...

Yes, that Lapp cable is the ultimate solution. There are lots of different styles, some with both power and signal connections bundled and screened...