New Activity ()
Please reload this page to view the 200+ new activity items that have been created.
-
Older Activity
-
4 Hours Ago
Please see photos for driver, control board and stepper set up. I'm hoping the photos will prompt some more thoughts into the matter.
Many thanks.
3 replies | 114 view(s)
-
10 Hours Ago
Hi John,
Thank you for the reply - I have a copy of the A11 manual and have been through this multiple times.
I will triple check the...
3 replies | 114 view(s)
-
11 Hours Ago
Two possible causes occur to me. One is that there is an intermittent connection in the z direction wire, but you seem to have ruled that out. The...
3 replies | 114 view(s)
-
22 Hours Ago
Dear all,
I am new to this forum and looking for some advice about a current issue with my 8x4 CNC router.
The machine is branded under the...
3 replies | 114 view(s)
Help diganosing fault with chinese...