Activity Stream
-
Older Activity
-
7 Hours AgoFinally finished. We needed to strip down some of the machine to route the wiring, then it was time to upload all the information to GitHub.20 replies | 155292 view(s) -
4 Days AgoHi Group I have a mach 3 controller running on a small lathe. it is not currently set up with limit switches on the auto indexer, and sometimes...0 replies | 373 view(s) -
2 Weeks AgoHi, I am hitting a problem trying to calibrate my milling machine. The stepper drivers are leadshine AM882 running 12nm motors on 4 amps. However I...0 replies | 1107 view(s)
-
2 Weeks AgoHi, I am having problems with installing the firmware for my CSMIO/IP-S controller. I have see the network to the correct IP address and network...0 replies | 970 view(s)
-
2 Weeks AgoMore development, more testing . . .20 replies | 155292 view(s)
-
2 Weeks AgoAnd depending on your actual needs @NITRAM, you could do yourself a favour (and possibly extend your initial budget) and buy a UK-built CNC machine...2 replies | 2126 view(s)
-
3 Weeks AgoHi nitram, welcome aboard. I'm actually logging in after quite a long absence from the forum, having built my machine some years ago and now just...2 replies | 2126 view(s) -
3 Weeks Agohi .Denford novaturn cnc topboard wanted or just eprom chip . thanks [email protected]0 replies | 1643 view(s)
DIY spindle stall monitor