Activity Stream

Nice video. How is the machine now after a few years of use? Are you happy with it? Isn't 400W too weak? Just last week I bought a similar one, but...

I think the answer to that should be it depends on what you are working with and want to extract. I mean, personally, I don't use any mechanical...

Sounds like a leak to me (interference perhaps?), check all your earth (ground) wires are secure, make sure no control and power wires are in close...

They look OK, don't speak Polish You didn't say what you wanted machine wise so hard to judge and we buy 2nd hand mostly lol Just remember...

Lmao, a "McWine" haha :applause::beer:

hi chris i just went with the makita router . thought i could always upgrade later if i needed it

X axis gantry, cheap linear rails quick look, new Z axis touch off (again!) and Y axis movement.

Oops! Apologies I inserted the wrong link, the one I'm using has only one relay: ...

I have had a beer in McD's It was anti climatic It came in a can like a store I wanted a paper cup McD's beer!!!! Lithuania, they sold...

Wait...what?!?!... McDonald's do wine? Red or White?

Apologies for thread hijack, but perhaps John, or anyone using this ubiquitous board, can clear up a confusion with pins on the above board which I...

Youtube is your friend for what to do with it and upgrades Buy everything from Alixpress Good luck Honestly for this machine Vcarve is a...

I will do. I had an HPC CNC machine (from Halifax) for about 3 years and sold it in lockdown for almost twice what I paid for it. Due to health...

Thanks Chris . Appreciate the offer, I may switch but as I have a years free subscription when I bought the onefinity I am just going through all the...

Hello Dan. Im doing this a bit backwards. Im getting the software to master before I buy the CNC machine. Ive done down the route of Vectric...

Thanks. Can you let me know an idea of pricing. Not specifically looking at the centroid servo motors however that might be of interest if you have...

here are some pictures

Toolpath can do it according to AXYZ I asked them, I did not ask them about using a switch lol as they want to sell the USB device so will say no...

Cheers Andrew, I will post it there too, great advice as the more people who see it the better chance I'll have of getting help. Hi Chaz, yeah...

Hi, can you share pics please - specifically interested in the spindle / toolchanger and a set of rails / ballscrews that I could use for a Z axis...

You need to understand the modes. Position is step / direction. Speed is -10 to 10V. This is specific to the servo / driver and has nothing to do...

There is no need for DNC if your controller works.It is only really justified if the controller is in poor order or if the file you are trying to run...

Hi Bud I have just purchased the Creality otter scanner and i really am impressed with it , not that i am an expert . far from it but i really am...