Activity Stream

I nearly finished to install the ATC and macros nearly all works, except some problems with G modes in macros if something go wrong. I started to...

I've been using them on both my lathes and they have been fine. There's no real option to tune the drives themselves but you can tune the higher...

Hi people..... Does anyone use the RS485 on this VFD??? I cant seem to find any documentation for the pinout OR the address registers and data...

@Muzzer - Did you ever get the Lichuan A4 and servos running and tuned? I am thinking of buying these, but the lack of support for the tuning...

Oh my God. What is that?

I made a video regarding this upgrade and the making of the tool post holder screw and nut.

3D bust of musician, sculpted by me for bronze casting. (It's not a photo, but render of 3D model).

id like to keep the machine original with the AXYZ computer, but it may be that my only option is to replace with another control system.

I may misunderstand the function of an RS485 driver,is it not to enable a comms protocol?I would imagine that the protocol,once activated,would allow...

Thanks M8. ive created another post so i dont overtake this one. mine is a AM2C i hope you can help. thank you in advance.

:unconscious:

how many of those drivers are set to the pin-out AXYZ uses?

. my first 4 years of programming were spent with toolpath. back then, it actually was pretty powerful program. it just took a lot of patience to...

Wonderful toolpath program? Now I have seen everything! I thought it was an abomination and barely workable,but I have a much higher regard for XP...

get a generic converter, use whatever CAM software you want, spend 50 dollars or pounds or whatever on an old XP Pro machine and then go to AXYZ...

he would be fine to erase the the Operating system intentionally if he wanted, its Function 159. the parameters and settings are stored in both the...

I don't think function 18 is what you want. its only the for setting the operator preferences. nothing to do with the replacement of parts or...

Instead of on top cast the steel within the mineral casting (Epoxy granite to some) https://www.model-engineer.co.uk/forums/postings.asp?th=139042...

I have an AXYZ router in Australia. I'm replacing the driver with a generic driver as the original driver is 32x the price. How ever I cant get...

Stepper frequency will be the result of the steps per unit, and the feedrate. It's been a while since I've used Mach 3, but I don't think you even...

There are different standards for pull studs. I had to get a batch custom made, as I couldn't find anything suitable.

If you do a search for RS485 drivers,quite a few sources appear.

you can certainly try an Ebay version. its probably a lot cheaper. the drivers for the converter are part of the ToolPath disk, along with the all...

just received some gorgeous bt35 chucks with er20 collet from aliexpress. very well made. shame pull stud is too long for my triac... will try to...