View Full Version : Optical measuring device
CNCDev
05-11-2016, 02:00 PM
Hi,
Does anyone know where this device is used? The two lines moves across the lense when I turn the wheel.
Brian.
John S
05-11-2016, 05:36 PM
Its off a Russian cruise missile
Clive S
05-11-2016, 05:39 PM
I thought it was to find Deans small odds and ends
JAZZCNC
05-11-2016, 07:18 PM
I thought it was to find Deans small odds and ends
Nothing Odd about my small end. . :triumphant:
CNCDev
05-11-2016, 07:33 PM
There are obviously several small things it can measure... ;-) On another website I was told that it is used for setting tool offsets, which also makes sense.
Brian.
mekanik
06-11-2016, 11:19 AM
It looks like it's used as described on other website,it measures a linear offset, clamped to one jobby after rough alignment with the indexing arm and the offset of whatever read off the indicator dial after the target has been aligned.
Perhaps.
Mike
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.