NEW MEMBER: New to MYCNCUK [Archive]

View Full Version : NEW MEMBER: New to MYCNCUK

Fgc

13-01-2017, 08:17 PM

Dear all

for some reason my earlier message failed to post.

I am in the process of rebuilding a few dead machines

Denford Starmill ATC
Denford Orac ATC
Emco VMC 100

Thank you in advance for your kind help and advise.
Francis

Chaz

14-01-2017, 07:44 AM

Welcome.

http://www.denfordata.com/bb/ is your friend for any Denford info. Numerous on the forum also have Denford experience.

Are you going to be rebuilding to Mach 3 or something else?

Fgc

14-01-2017, 09:11 AM

Hi Chaz

I'm rebuilding to Mach3 for the StarMill and Orac but will probably use a standalone panel for the Emco VMC100

Chaz

14-01-2017, 03:48 PM

Hi Chaz

I'm rebuilding to Mach3 for the StarMill and Orac but will probably use a standalone panel for the Emco VMC100

Cool, why different? What panel are you considering?

magicniner

14-01-2017, 04:55 PM

Moving to industry standard dialects of G-Code allows use of a wide range of CAD/CAM systems?

Fgc

14-01-2017, 05:48 PM

I am going mach3 only because I had an old license from many years ago so the cost to me is a set of smoothstepper board. But if I were to do it again I would probably go with a dedicated panel. Mach3 license plus smoothstepper and breakout total 2/3 the price of one of the indistrial looking panels that support standard G/M codes. Also these panels support ATC (which I think will be easier to get going too) rather than have to write a bunch of macros.