View Full Version : HB04 pendant macro help
etched4u
14-02-2017, 05:16 AM
Can anyone point me in the direction for instructions to program the macro buttons on a HB04 pendant, the instructions in the manual are vague at best.
Thanks
Steve
PS I am using Mach3
Skiprat
05-03-2017, 06:48 PM
Hello
I'm sure if you go into the configure plugins section of mach3 and find the pendant line and press configure, it should bring up a configuration page which has the buttons on it which you can program the pendant.
It does on mine if this helps.
Cheers Tommy
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.