Chaz
29-09-2017, 08:08 AM
So after a battle I managed to get these to work last night.
Work is maybe a strong word.
The confusion is around microstepping and what impact that has on my steps / mm calculation.
The higher I set the microstepping, the smoother the stepper turns. I am using fairly old stepper, around Nema 32 size, 6 wire, using the full coil on each A and B.
Is the logic correct that if I use a low step / rev number, this impacts Mach 3's step/mm value? So If I use 200 for example, my Mach 3 setting could be something like 400 however if I moved to 1600 (8 times more steps), the value in Mach 3's motortuning moves proportionally?
This means then that if I am running 25600 microsteps, I could have a large number for steps / mm in the motor tuning?
Problem that I have, if I do that, Mach 3 limits the speed I can run at. The net result is a slow but smooth motor.
Low microstepping = motor that runs faster but doesnt sound smooth.
Am I missing something? What does Mach 3' motor tuning modify the speed / velocity setting if I try and increase the step/mm value significantly? I can bullshit it by setting the velocity high, then using the settings -> mach 3 steps tool however doesnt seem right.
Thanks
Work is maybe a strong word.
The confusion is around microstepping and what impact that has on my steps / mm calculation.
The higher I set the microstepping, the smoother the stepper turns. I am using fairly old stepper, around Nema 32 size, 6 wire, using the full coil on each A and B.
Is the logic correct that if I use a low step / rev number, this impacts Mach 3's step/mm value? So If I use 200 for example, my Mach 3 setting could be something like 400 however if I moved to 1600 (8 times more steps), the value in Mach 3's motortuning moves proportionally?
This means then that if I am running 25600 microsteps, I could have a large number for steps / mm in the motor tuning?
Problem that I have, if I do that, Mach 3 limits the speed I can run at. The net result is a slow but smooth motor.
Low microstepping = motor that runs faster but doesnt sound smooth.
Am I missing something? What does Mach 3' motor tuning modify the speed / velocity setting if I try and increase the step/mm value significantly? I can bullshit it by setting the velocity high, then using the settings -> mach 3 steps tool however doesnt seem right.
Thanks