Tormach for sale

[ste64]

Hi all got a Tormach PCNC 1100 for sale, 4th axis and tooling to be included. The machine was purchased early 2016 and is in superb condition. Total machine cost was approximately £11,000 looking for £7000. Pictures can be sent to serious parties.

[Spurry]

Further details/pix would be very much appreciated. Unfortunately I do not seem to be able to PM you.
Pete

[Aitch]

Hi, I'm interested but can't PM you as I haven't previously posted. Could you PM me with alternative contact details please?
Harry

[ste64]

Pictures as requested
Some of the machine extras are:
Power drawbar, automatic oiler, hand wheel and 4th axis with 3 jaw chuck.
The machine can be seen running at my workshop on the west coast of Scotland.
The software is pathpilot V9.7
I hope this helps
Steve

[mh996]

Hi, I'm interested in the Tormach. When would be a good time to come and view it? Were in Scotland are you?
Many thanks
Mark

[needleworks]

PM sent

[chas-SX3]

PM Sent

[ste64]

Hi Guys
Machine sold :beer:
Thanks for all your interest
Steve

[mh996]

Hi, I've tried to get in touch several times today and still not sure you are getting my messages. I'm interested in the mill please get in touch.
Mark

[ste64]

Hi Mark
Sorry but its sold..
Steve

[needleworks]

Hi Guys
Machine sold :beer:
Thanks for all your interest
Steve

Nice one mate, I didn't think it would sit there long:victorious: