Fgc
26-10-2017, 05:13 PM
Dear all
I am new to using the PC Turn 55 running Camconcept software connected via Ethernet.
I have not been able to get the spindle to spin up. I do not know what I am doing wrong in inputting spindle speed. When I attempted to run a program, the lathe turret will rotate to the correct tool and move itself into position and then I can hear a soft high pitch sound from the lathe followed by this message "Turning Cycle 6014 No main spindle speed".
I have input the spindle speed for roughing and finishing in the tools section. Am i missing something?
The Emco Camconcept user manual is the absolute worse manual I have ever come across. it does not explain anything!
Please help. I cannot get the spindle to spin.
Thanks
frank
I am new to using the PC Turn 55 running Camconcept software connected via Ethernet.
I have not been able to get the spindle to spin up. I do not know what I am doing wrong in inputting spindle speed. When I attempted to run a program, the lathe turret will rotate to the correct tool and move itself into position and then I can hear a soft high pitch sound from the lathe followed by this message "Turning Cycle 6014 No main spindle speed".
I have input the spindle speed for roughing and finishing in the tools section. Am i missing something?
The Emco Camconcept user manual is the absolute worse manual I have ever come across. it does not explain anything!
Please help. I cannot get the spindle to spin.
Thanks
frank