View Full Version : Chester Champion 20v Mill
amxen
21-02-2018, 10:37 PM
Hi there im trying to find out what the Chester Champion 20v Mill is . My plan is to convert it to cnc with a kit but i need to know is it the same as the Grizzly G0704 ? or the PM-25MV ? or something else. You can get kits for most of them but they arnt all the same . So i need to know what it is befor i order the wrong thing ? Any one have any Idea ?
ThanksMick
spluppit
21-02-2018, 11:10 PM
Ask Chester machine tools...?
I very much doubt Chester would tell you.
Most of these machines, especially from the bigger suppliers, all have slight variations. I know a couple years ago I looked at something G0704 like, and out of all the different machines around that size I looked at (around 8 to 10 IIRC), they all had slightly different specs. Some were obvious things like different spindles, and others were more subtle like axis having slightly different amounts of travel.
amxen
22-02-2018, 12:28 AM
Iv msged Chester 3 or 4 times without reply. It's the bolt holes for the bearing mounts that's most important. If these are the same as the grizzly I know I can bolt the kit on. I can work around the rest
dazp1976
27-10-2018, 09:27 AM
Don't bother with the Chester imo.
1. The Y travel is way short at 155mm.
2. The taper MT2, no thanks!
A better variant is the AMAT25LV from Amadeal. R8 taper avail which is best imo. Has more powerful motor, belt driven, higher rpm. If you're going to spend around £1200 then for me that's the one to get (and I am).
There's no guarantees the G0704 kit will fit any of the variant mills I'm afraid but the one I've mentioned has the best chance.
amxen
27-10-2018, 10:25 AM
Haha this is old news IV already CNC ed it
dazp1976
27-10-2018, 12:32 PM
Haha this is old news IV already CNC ed it
Ha ha :D
Realised after I posted it. Not much activity on this site most of the time.
Did the kit fit the Champion then mate? Or you go with something else.
amxen
27-10-2018, 01:04 PM
Yer got the kit from Arizona 99 fit really well and easy
dazp1976
27-10-2018, 05:09 PM
Yer got the kit from Arizona 99 fit really well and easy
They look pretty smart his kits.
My AMAT25LV should be here on Friday.
Just about to start re-building my Seig X2 so it can make a kit for the 25.
It's a bit worse for wear atm and I want it bang on.
Then it's a case of measure up, order some double nut screws from China (re-shim them), make some mounts & get some Oldham coupling inserts from RS and make some hubs.
What could poss go wrong!!! lol.
If it goes belly up I'll have a word with Arizona :D
Kolin
15-08-2022, 09:04 PM
Hey,
Sory for startiung up this old thread again, but was it the PM-25 kit from Arazona 99 you went with for the Champion 20v??
Thanks,
Kolin
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.