PDA

View Full Version : DIYCNC version 2 board


Clive S
09-03-2018, 01:06 PM
As the title DIYCNC version 2 board does anybody have a manual please?
magicniner
09-03-2018, 09:19 PM
I looked back through their website's various incarnations and couldn't find a Version 2 board

https://web.archive.org/web/*/www.DIYCNC.co.uk
Clive S
10-03-2018, 01:11 AM
I looked back through their website's various incarnations and couldn't find a Version 2 board

https://web.archive.org/web/*/www.DIYCNC.co.uk

Yes thanks I had checked that. I am using this as an experiment because it can accept at 15-70 V and then give out 12V and 5V with its built in regs. I am also using one of those crap Chinese bobs to drive a mill with 3 mpg's and separate homing on each axis. with Linuxcnc. The crap board needs 12-24V plus 5V. I will then have 10 inputs 6 for the mpg's and 3 for the homing etc.
magicniner
10-03-2018, 01:17 AM
So if it didn't feature anywhere on DIYCNC's site is it one of the currently available Chinese boards?
JAZZCNC
10-03-2018, 09:57 AM
I looked back through their website's various incarnations and couldn't find a Version 2 board

https://web.archive.org/web/*/www.DIYCNC.co.uk

That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.
Clive S
10-03-2018, 10:31 AM
That's because It's actually an Opto V3.? Roy only supplied V2 for a very short time but this board Clive as is V3, even thou marked v2. The reason I know is that I gave it to him.

Thanks for the manual Dean:thumsup: