amer_uk
01-07-2018, 07:38 AM
Hello all
I've just acquired a Boxford VMC 190 from ebay. It is missing its spindle cover, but other than that, mechanically it looks good.
I will be upgrading it to Mach3.
I need help with the following:-
1. Parts diagram / User manual
2. A few pics of the spindle cover.
3. What is the small box attached to the left of the spindle cover ?
4. Tool holder does not drop out when i move the drawbar handle up or down. Where should the handle be to remove it, and how do I remove it as its stuck (Machine been stood for a while.
PLUS
Is there some good write ups / instructions to upgrading the machine to Mach 3 ?
IS there any dismantling instructions for the machine (spindle/slides) for a deep clean ?
Thankyou
Amer
07944905095
I've just acquired a Boxford VMC 190 from ebay. It is missing its spindle cover, but other than that, mechanically it looks good.
I will be upgrading it to Mach3.
I need help with the following:-
1. Parts diagram / User manual
2. A few pics of the spindle cover.
3. What is the small box attached to the left of the spindle cover ?
4. Tool holder does not drop out when i move the drawbar handle up or down. Where should the handle be to remove it, and how do I remove it as its stuck (Machine been stood for a while.
PLUS
Is there some good write ups / instructions to upgrading the machine to Mach 3 ?
IS there any dismantling instructions for the machine (spindle/slides) for a deep clean ?
Thankyou
Amer
07944905095