dazp1976
19-08-2018, 11:23 PM
Thinking of getting one of these for a spindle project:
https://www.aliexpress.com/item/130ST-M06025-AC-servo-motor-1-5KW-6N-M-1500W-AC-Servo-Motor-and-driver-G121B/32355475440.html
Want to interface it into mach3 in speed/torque control mode for on/off & speed 0-10v. Also for e-stop to trigger mach if motor jams/stops if poss.
Anyone used one before?
I can only find Chinese wiring instructions around and wouldn't have a clue which pins to use on the DB25 interface. Or if it can work with mach. Anyone here in the know?
There is already a relay and 0-10v out on my BOB ready to use. And could tie it into my existing e-stop circuit.
Would rather know before I throw money at it.
Daz.
https://www.aliexpress.com/item/130ST-M06025-AC-servo-motor-1-5KW-6N-M-1500W-AC-Servo-Motor-and-driver-G121B/32355475440.html
Want to interface it into mach3 in speed/torque control mode for on/off & speed 0-10v. Also for e-stop to trigger mach if motor jams/stops if poss.
Anyone used one before?
I can only find Chinese wiring instructions around and wouldn't have a clue which pins to use on the DB25 interface. Or if it can work with mach. Anyone here in the know?
There is already a relay and 0-10v out on my BOB ready to use. And could tie it into my existing e-stop circuit.
Would rather know before I throw money at it.
Daz.