Ade taplin
29-08-2018, 01:02 PM
Hi All,
I have finally got the above mill running retrofitted a CS labs motion controller with help from another forum user (Chaz). then discovered the servo drive was faulty on the Z axis I have had that repaired but now I get the occasional glitching where the z servo will just start glitching up and down eventually sending the drive unit into a fault. has anyone else experienced this or does anyone know what the problem could be.
regards
Ade
I have finally got the above mill running retrofitted a CS labs motion controller with help from another forum user (Chaz). then discovered the servo drive was faulty on the Z axis I have had that repaired but now I get the occasional glitching where the z servo will just start glitching up and down eventually sending the drive unit into a fault. has anyone else experienced this or does anyone know what the problem could be.
regards
Ade