BobE
26-11-2018, 05:58 PM
Hi,
I'm relatively new to the forum and posted just a couple of times.
I've just bought a Boxford CNC router for the batch production of small hardwood items.
I'm sure this has already been discussed, but can anyone with experience of the fine finishing of hardwoods recommend a good source for tooling.
Would I be better using a 10mm or bigger shank,rather than a 6mm? I've told that this will lessen vibration and some noise.
Any tips as to how to get a good finish would be much appreciated. Also any thoughts on a good source of information on the subject, online or books.
Many thanks,
Bob
I'm relatively new to the forum and posted just a couple of times.
I've just bought a Boxford CNC router for the batch production of small hardwood items.
I'm sure this has already been discussed, but can anyone with experience of the fine finishing of hardwoods recommend a good source for tooling.
Would I be better using a 10mm or bigger shank,rather than a 6mm? I've told that this will lessen vibration and some noise.
Any tips as to how to get a good finish would be much appreciated. Also any thoughts on a good source of information on the subject, online or books.
Many thanks,
Bob