PDA

View Full Version : Bridgeport Tips & Advice



Philmollatt
28-09-2009, 12:25 AM
Hello
Ive recently purchased a bridgeport seriesI milling machine and a colchester triumph mk1 and a half lathe, i have got two inverters ready to get them powered up from single phase, when ive got them running i'm going to attempt cnc conversion on the miller, anyone any experience with this, any tips , advice would be gratefully recieved.
Cheers
Phil

Ballot
30-09-2009, 11:04 PM
Hello
Ive recently purchased a bridgeport seriesI milling machine and a colchester triumph mk1 and a half lathe, i have got two inverters ready to get them powered up from single phase, when ive got them running i'm going to attempt cnc conversion on the miller, anyone any experience with this, any tips , advice would be gratefully recieved.
Cheers
Phil
Hi Philmollatt, for your Bridgeport conversion, you might like to have a look at this site and give the guy there a call www.routoutcnc.com The Mach 3 PC based Drive is very good and they can supply all the hardware you will need to built a stepper motor type conversion to your machine

Philmollatt
01-10-2009, 06:34 PM
Thanks mate, ill have a browse round thier site later