View Full Version : Need help finding a part
jasonvquick
14-01-2019, 02:27 AM
I have a control board out of a Denford Novamill and I believe a transformer was fried while doing some testing. I can't find a part number or a schematic for the board. The board says Baldor f391 issue 1 on it. Any info in finding a replacement part would be great thanks in advance https://uploads.tapatalk-cdn.com/20190114/742bd957b7ee641cea2c28c1d4d567a9.jpghttps://uploads.tapatalk-cdn.com/20190114/04dfd011398efa00f1aae15561cca20c.jpghttps://uploads.tapatalk-cdn.com/20190114/a99c3328bf5243f974b7cc210f567a89.jpg
Sent from my Pixel 2 using Tapatalk
Clive S
14-01-2019, 08:40 AM
That's a shame as I threw one of those boards out about two weeks ago from a conversion I have just done.
jasonvquick
14-01-2019, 11:10 AM
That is too bad. If I can't fix this one I'm not opposed to doing a conversion. Could you let me know what you bought to replace it?
Sent from my Pixel 2 using Tapatalk
Clive S
14-01-2019, 01:35 PM
That is too bad. If I can't fix this one I'm not opposed to doing a conversion. Could you let me know what you bought to replace it?
Sent from my Pixel 2 using Tapatalk
I used a Mesa 7i92 If I was doing it again I would use a Mesa 7i96 You you might not prefer Linixcnc
jasonvquick
02-03-2019, 04:03 AM
Update I replaced the board that was bad and now I have x y and z motion. I'm trying to get the spindle to come on and be controlled by the pot on the cabinet anyone have any advice?
Sent from my Pixel 2 using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.