Need help finding a part

[jasonvquick]

I have a control board out of a Denford Novamill and I believe a transformer was fried while doing some testing. I can't find a part number or a schematic for the board. The board says Baldor f391 issue 1 on it. Any info in finding a replacement part would be great thanks in advance https://uploads.tapatalk-cdn.com/20190114/742bd957b7ee641cea2c28c1d4d567a9.jpghttps://uploads.tapatalk-cdn.com/20190114/04dfd011398efa00f1aae15561cca20c.jpghttps://uploads.tapatalk-cdn.com/20190114/a99c3328bf5243f974b7cc210f567a89.jpg

Sent from my Pixel 2 using Tapatalk

[Clive S]

That's a shame as I threw one of those boards out about two weeks ago from a conversion I have just done.

[jasonvquick]

That is too bad. If I can't fix this one I'm not opposed to doing a conversion. Could you let me know what you bought to replace it?

Sent from my Pixel 2 using Tapatalk

[Clive S]

That is too bad. If I can't fix this one I'm not opposed to doing a conversion. Could you let me know what you bought to replace it?

Sent from my Pixel 2 using Tapatalk

I used a Mesa 7i92 If I was doing it again I would use a Mesa 7i96 You you might not prefer Linixcnc

[jasonvquick]

Update I replaced the board that was bad and now I have x y and z motion. I'm trying to get the spindle to come on and be controlled by the pot on the cabinet anyone have any advice?

Sent from my Pixel 2 using Tapatalk