Maxiscnc
24-02-2019, 01:15 PM
Hi everyone,
I'm very new with Siemens controllers and I have a problem with measuring the tools in the ATC. This is Emco PC Mill 155 with PC based WinNc Sinumerik 810D/840D control. I've measured all the tools with touch sensor ( 10 in the turret ) and saved the G54 zero offset to the top of the surface of a foam block.
All seems to be fine, but when tryed to start a simple program
------------------
G54
S2000 T2...10 M6
G0 Z0 F100
M30
------------------
some of the tools were in exact zero position but others are 10 - 15mm higher of the surface. One of them were few mm into the material.
I've measured again .. all of them and the result is the same.
What I'm doing wrong? Do I need to save it someware or to call for a special G command for tool compensation.
Any help is very welcome. Thanks
I'm very new with Siemens controllers and I have a problem with measuring the tools in the ATC. This is Emco PC Mill 155 with PC based WinNc Sinumerik 810D/840D control. I've measured all the tools with touch sensor ( 10 in the turret ) and saved the G54 zero offset to the top of the surface of a foam block.
All seems to be fine, but when tryed to start a simple program
------------------
G54
S2000 T2...10 M6
G0 Z0 F100
M30
------------------
some of the tools were in exact zero position but others are 10 - 15mm higher of the surface. One of them were few mm into the material.
I've measured again .. all of them and the result is the same.
What I'm doing wrong? Do I need to save it someware or to call for a special G command for tool compensation.
Any help is very welcome. Thanks