Scustom
01-06-2019, 09:29 PM
Hi all
Just expirementing with different ideas,did someone ever build something like this,I know wiremonkey experemented with stiffening c beam with steel tube(how did that ended btw?) but this is not wor stiffening purposes,more to clear ballscrew and bringing spindle closer to x axis.
Idea is to cut open middle section of steel beam and weld half piece of 50X50 to clear ballscrew nut.I know joints are week points so 50X50 could be 3-4mm thick wich is I think more than enough.
Opinions are welcomed.
thanks
Just expirementing with different ideas,did someone ever build something like this,I know wiremonkey experemented with stiffening c beam with steel tube(how did that ended btw?) but this is not wor stiffening purposes,more to clear ballscrew and bringing spindle closer to x axis.
Idea is to cut open middle section of steel beam and weld half piece of 50X50 to clear ballscrew nut.I know joints are week points so 50X50 could be 3-4mm thick wich is I think more than enough.
Opinions are welcomed.
thanks