dlm4473
02-06-2019, 07:12 PM
Hello All
Im about to start restoring an old cylinder mower, and due to an engine replacement I am looking for someone to machine a steel clutch pully which is currently 5/8 - to fit on a 3/4 shaft inc keyway.
I have contacted a couple of local engineering firms and didn't even receive a response - too small a job for them I suppose?
Anyway, if anyone is willing to do this, at a reasonable cost , or even recommend somewhere local to myself (Tayside) I would be much obliged .
Many Thanks in advance
D Macrae
Im about to start restoring an old cylinder mower, and due to an engine replacement I am looking for someone to machine a steel clutch pully which is currently 5/8 - to fit on a 3/4 shaft inc keyway.
I have contacted a couple of local engineering firms and didn't even receive a response - too small a job for them I suppose?
Anyway, if anyone is willing to do this, at a reasonable cost , or even recommend somewhere local to myself (Tayside) I would be much obliged .
Many Thanks in advance
D Macrae