Wanted Denford spares

[pixelabstract]

Hi, If anyone has upgraded their denford to mach3 and have the original parts ie stepper board etc then I would be interested in purchasing those parts.
Please contact me
Thankyou

[Chaz]

Ive got some stuff in a box but mine had servos, so might not be of use to you, correct?

[pixelabstract]

Ive got some stuff in a box but mine had servos, so might not be of use to you, correct?

Hi Chaz,

I bought a denford microrouter which does not have servos, the Y axis on my machine does not work , just seems to judder, after eliminating the obvious causes there is a strong possibility that the lower driver board has gone. I think the top motion controller is ok but wont say no to a spare one.

I do not have extensive electronic knowledge and was wondering if I could get the same board and plug it in that might do the trick.

Ive attached the photograph of the board if the one you have is like this one then yes I would definitely like to give it a go, depending on the price he he he :smile:

Thanks

[Chaz]

Ok, ill need to dig out the box, somewhere in storage.

[Edendale]

I have a stepper & controller board, came out of a working machine that was converted to Mach3 29965299652996529966

[Adri123]

Hi. Do you still have the controller boards Edendale? Thanks. Nick

[Edendale]

Hi. Do you still have the controller boards Edendale? Thanks. Nick

No sorry nick

[GND]

Hi Nick,

FWIW, I have an older version of the plug-in board - the board on the left of the pictures in the previous posting, the one without the orange connectors and power devices. Mine has an RS232 interface and came from a working machine. Is that of any use?

Graeme

[csuritattoo]

hi! I am looking for controll card for denford novamill . many thanks

[GND]

Hi Csuritattoo,

I tried to PM you but your profile didn't allow it. I have a believed fully working serial type Novamill control card which is spare. Please feel free to PM me if it is of any interest.

All the best
Graeme

[csuritattoo]

hi. thank you but unfortunatelly I post wrong parts needed. i looking for NOVATURN control card . sorry and many thanks