Palletlad
14-09-2019, 10:44 PM
Hi all,
I installed switches to my 6040 today (parallel running 2xX 2xY 2xZ) and cannot get mach3 to register them.
I am using a UC400eth controller so no printer cable connection used and i have tested the physical side which all checks out correctly done. i set them as pin 11,12 and 13 for xyz home. any suggestions on what I'm missing?
Almost forgot i set them up as open circuit.
Kind Regards
I installed switches to my 6040 today (parallel running 2xX 2xY 2xZ) and cannot get mach3 to register them.
I am using a UC400eth controller so no printer cable connection used and i have tested the physical side which all checks out correctly done. i set them as pin 11,12 and 13 for xyz home. any suggestions on what I'm missing?
Almost forgot i set them up as open circuit.
Kind Regards