MegaformSteve
20-04-2020, 12:45 PM
Hi All,
Newbie here !
We have a Pacer 1250 that we inherited when we purchased some other equipment at auction. It is sitting gathering dust as we have a 5 axis Geiss which is performing ok. We now have a requirement for some 3 axis machining and would like to get this up and running.
It has no heads by the look of it and the interface came with a Win 98 PC !!!
Any clues or helpful hints? We had thought of selling it or stripping it down for parts, but would prefer to get it up and running.
Thanks in advance for any suggestions !
Newbie here !
We have a Pacer 1250 that we inherited when we purchased some other equipment at auction. It is sitting gathering dust as we have a 5 axis Geiss which is performing ok. We now have a requirement for some 3 axis machining and would like to get this up and running.
It has no heads by the look of it and the interface came with a Win 98 PC !!!
Any clues or helpful hints? We had thought of selling it or stripping it down for parts, but would prefer to get it up and running.
Thanks in advance for any suggestions !