marbles
22-04-2020, 10:06 PM
Simple one this but its stumped me.
When I press go to zero I want it to raise from the stock to safe Z height and traverses back across to Z and then go down. At the moment it does the opposite and skims across the stock (at Z0 I presume) until it reaches zero.
Can't for the life of me find the the Mach 3 checkbox to alter this and I'm pretty sure it was something as striaghtforward and checking or unchecking a box somewhere.
Any suggestions?
When I press go to zero I want it to raise from the stock to safe Z height and traverses back across to Z and then go down. At the moment it does the opposite and skims across the stock (at Z0 I presume) until it reaches zero.
Can't for the life of me find the the Mach 3 checkbox to alter this and I'm pretty sure it was something as striaghtforward and checking or unchecking a box somewhere.
Any suggestions?