PDA

View Full Version : RFQ: RFQ: Vintage Camera Parts



alanambrose
28-10-2009, 01:09 PM
Hi,

I'm also looking for a CNC service to make some vintage camera parts for me. I'm imagining that there should be a service out there, but several hours on the web hasn't turned up much except for eMachineShop.

BTW I did find CNC for motorcycle parts (see below).

Regards,

Alan

http://www.themuttznutz.com/
http://radicalcustommotorcycleparts.com/
http://www.cjs-engineering.co.uk/

alanambrose
28-10-2009, 01:18 PM
I should say that the service would ideally take a supplied cad file rather than drawings.

Alan

HiltonSteve
29-10-2009, 05:35 PM
Do you have any drawings or photo's of the type of parts that you are after, anything to give us an idea will do for now.

alanambrose
30-10-2009, 04:43 PM
OK a dxf and some slightly dodgy jpgs. Of course being vintage, the tolerances are not bothersome +-0.5mm should be fine.

Alan

John S
30-10-2009, 07:16 PM
1.39 metres ?
Is this for Jodrell Bank?

.

alanambrose
02-11-2009, 05:01 PM
139mm x 4mm although I like the sound of 4cm aluminium a lot :)

Alan