HankMcSpank
09-11-2009, 12:37 PM
Ok, so I bought a mini lathe off Ebay ...which came without a chuck. Now I'm clueless about a lot of things in life & I put lathes in that category. A lot of reading ensued the outcome being I though a 4 jaw independent chuck would be my best option - quack, quack oops ...it's such a chore to use, that I'd rather drill my kneecaps than have to go through the arse of lining a bit of material up! (which means it's not getting any use)
Now, since I mainly work with small round bar type stuff...I now realise that a collect chuck would be a far better (quicker!) option.
But I'm overwhelmed at the options...can any of you good folk here, help me choose the 'best bang per buck'.
My mini Axminister (C2 300A) lathe has an MT3 spindle, I envisage working with round bar in the region of 3mm-10mm.
This is just a hobby & I'm not a heavy user, so I don't want to pay a massive premium for top notch quality, but I don't want to be cursing everytime I change a collet either!
Many thanks!
Now, since I mainly work with small round bar type stuff...I now realise that a collect chuck would be a far better (quicker!) option.
But I'm overwhelmed at the options...can any of you good folk here, help me choose the 'best bang per buck'.
My mini Axminister (C2 300A) lathe has an MT3 spindle, I envisage working with round bar in the region of 3mm-10mm.
This is just a hobby & I'm not a heavy user, so I don't want to pay a massive premium for top notch quality, but I don't want to be cursing everytime I change a collet either!
Many thanks!