View Full Version : Heart shaped trinket box

21-11-2020, 08:41 PM
My first attempt at cutting oak. Just a little something for my girlfriend from a few offcuts of oak, I must say it cuts really well. The box was modelled using vcarve and I created a 3d printed jig for holding the heart lid while profiling the top.


Sent from my M2003J15SC using Tapatalk

21-11-2020, 09:34 PM
Nice work Charlie.:applause:

But whatever you don't put a ring in that box and get down on one knee otherwise it will be the last Oak you cut..:smiley_simmons:

21-11-2020, 09:48 PM
Cheers Jazz, there's no danger of that happening....I learned the hard way [emoji16]

Sent from my M2003J15SC using Tapatalk

25-11-2020, 07:58 PM
Holy Cow!
That's an amazing piece :0
I love this project showcase section only because of this beautiful and innovative work. Keep going :)