VFD YL620-A2.2KW 220V and 2.2KW water cooled spindle settings

[A11an]

Hi, can anyone help me out with the setting for the VFD YL620-A2.2KW 220V and 2.2KW water cooled spindle?

I bought my spindle and VFD 5 years ago and never used them, however I've now fitted them on a CNC router and the VFD failed so trying to add the VFD YL620-A2.2KW 220V (Amazon) but don't want to damage the spindle.

I have done a factory reset P0.13 =10

Is there some standard starting setting?

If I'm wasting my time with the VFD please tell me, as I'll send back but obviously want to get it going.

many thanks

Allan

[Clive S]

The one you have will work. But I am not familiar with this it.

The one that I would use (if you could send it back) would be the tried and tested :-

https://www.ebay.co.uk/itm/Speed-Control-2-2KW-3HP-220V-Huanyang-Variable-Frequency-Drive-Inverter-VFD-10A/402317393197?hash=item5dabfc3d2d:g:aTsAAOSw97RfAuI N

some of the important settings is the motor number of motor poles I think it is 2 if you have the Chinese 2.2kw spindle

and the input voltage & current. Also the max frequency 400Hz so the the spindle will run at 24K

[Doddy]

Have a look here... https://en.industryarena.com/forum/huanyang-chinese-vfd-settings-manual-here--117782-33.html, reply 655.

Don't know this VFD at all, so can't advise further other than Google is your friend.

Clive's advice above about getting motor poles/voltage is perfectly sound. You'll hate me for saying this but I wouldn't have recommended resetting any parameter without first going through the lot and recording the delivered pre-sets.

[A11an]

I've just found this sheet that is to the VFD I have, I've set as listed but not sure about the middle & low frequency & voltage settings, they don't look right to me, I'll attach a copy

thanks

Allan

[A11an]

I've seen a post with these setting?

P00.00 – 50Hz
P00.04 VF highest output frequency – 400Hz
P00.05 VF maximum voltage output frequency - 400Hz
P00.06 VF highest output voltage – 100%
P00.07 VF middle frequency – 200Hz
P00.08 VF middle voltage – 50%
P00.09 VF minimum frequency - 120Hz
P00.10 VF minimum voltage – 30%

but the manual say's

P00.00 – 50Hz
P00.04 VF highest output frequency – 400Hz
P00.05 VF maximum voltage output frequency - 400Hz
P00.06 VF highest output voltage – 100%
P00.07 VF middle frequency – 40Hz
P00.08 VF middle voltage – 10%
P00.09 VF minimum frequency - 4.0Hz
P00.10 VF minimum voltage – 1%

confusing!

[JAZZCNC]

I wouldn't worry about the differences as none will stop it from working or damage it.

[A11an]

Hi JAZZCNC

do you think the top settings seem more reasonable
?

Allan