Brain gone dead M10 x 20 htreaded inserts ?

[Fivetide]

I have a 20 mm hole I I want to use 10mm bolts through them is this the right one for the job ?

https://www.ebay.co.uk/itm/M10-x-20-25mm-HEX-DRIVE-SCREW-IN-TYPE-D-CSK-THREADED-INSERT-BUSHING-FOR-WOOD/201517662198?hash=item2eeb637ff6:g:4U4AAOSwB4NWud--

Thanks guys :)

[JAZZCNC]

Don't think so. The 20 or 25mm refers to the length I think.

[mekanik]

Hi Fivetide
That hole is way too big for a 10mm insert, have a look @ this
https://www.tappex.co.uk/products/brass-threaded-inserts/foamsert#selector
Not tried to find a 10mm one but you can get an idea of the wall thickness. If you have a lathe you could make your own, i did so for my window project, Tappex sent me 12 samples and i just copied them(they seemed expensive @ the time and i needed 48)
Obviously you would have been better finding your insert before drilling the hole.
Regards
Mike

[Fivetide]

Hi Fivetide
That hole is way too big for a 10mm insert, have a look @ this
https://www.tappex.co.uk/products/brass-threaded-inserts/foamsert#selector
Not tried to find a 10mm one but you can get an idea of the wall thickness. If you have a lathe you could make your own, i did so for my window project, Tappex sent me 12 samples and i just copied them(they seemed expensive @ the time and i needed 48)
Obviously you would have been better finding your insert before drilling the hole.
Regards
Mike

The project is a bit different, but I sort of worked out a work around.
I'll be using some 20mm steal tube with 5mm wall and then a thread 10 mm fix insert.
Thanks for the suggestions though.