GREG021
16-02-2021, 06:08 PM
Hi All
Please excuse my lack of knowledge.
Can anyone help me? I am trying to connect my XSY-AT1 to a Gecko G540 using a relay to control the motor with MACH3.
My problem is trying to work out the correct connections on the VFD.
See attached photo. I wish to connect the outputs from the relay to For and DCM which are not labelled on the XSY-AT1. It looks like I should use X4, can someone verify if I have this correct.
Thanks in advance.
Greg
Please excuse my lack of knowledge.
Can anyone help me? I am trying to connect my XSY-AT1 to a Gecko G540 using a relay to control the motor with MACH3.
My problem is trying to work out the correct connections on the VFD.
See attached photo. I wish to connect the outputs from the relay to For and DCM which are not labelled on the XSY-AT1. It looks like I should use X4, can someone verify if I have this correct.
Thanks in advance.
Greg