Denford microrouter extraction

[Edendale]

I have just purchased a Denford microrouter that is fully encased, it is fitted with a dust shoe and hose to the side of the cabinet, the hole for the extractor hose is approx 34mm, most extractors have a 100mm hose, on my extractor I have an adapter for a 40mm hose I used as a vacuum to clean up but it reduced the suction considerably, could someone point me to an extractor that would suit the router please. Regards Mike.

[andy_con]

works a treat with the microrouter

https://www.screwfix.com/p/scheppach-ha1000-183m-hr-electric-dust-extractor-240v/15408#_=p

[Edendale]

I was looking at this extractor but which end do you reduce the hose from 100mm to 32mm or will it not make a difference. Also could you tell me what the parts are in photo, I’m assuming they are to hold down a waste board, seems like something is missing.29942

[andy_con]

I was looking at this extractor but which end do you reduce the hose from 100mm to 32mm or will it not make a difference. Also could you tell me what the parts are in photo, I’m assuming they are to hold down a waste board, seems like something is missing.29942

no idea what the yellow things are.

the black aluminium bars, of which there should be three are for resting the spool board on

[Edendale]

Great thanks for that information, I have to try and find another one, ��

[andy_con]

Great thanks for that information, I have to try and find another one, ��

just get some u bar off ebay and make one.

[Edendale]

Good idea Thankyou ��